Wood Chipper 15hp 350Pro

It may be helpful to better familiarize yourself with the features of your Wood Chipper before beginning the steps outlined in this chapter.

Starting

1.         Position your Wood Chipper on flat, dry ground, make sure the machine cannot be moved.

2.         Make sure the fuel shut-off valve is in the “ON” position.

3.         Move the choke control lever to the “CHOKE” position (should only be needed if the engine is cold).

4.         Move the throttle control lever to the “FAST” position.

5.         Recoil Start: Turn the Ignition Switch to the “On” position. Grasp the recoil starter handle and slowly pull until you feel resistance. Let the cord retract a little bit then pull the cord rapidly to start the engine. One or two pulls usually starts the engine.

6.         Electric Start: Turn and hold the Key in the start position until Engine starts then let the Key return to run position.

7.         Move the choke control lever (if used for cold engine) slowly back to the “RUN” position when the engine is running well.

8.         If the Wood Chipper has not been running (cold engine), warm up the engine by running the engine at half throttle for 3 to 4 minutes, then advance the engine throttle control to the maximum speed.

Stopping

1.         Move the Throttle Lever to IDLE.

2.         Recoil Start: Turn the Ignition Switch to the OFF position.

3.         Electric Start: Turn the Key to the OFF position.

Operator Zone

Wood Chipping